Implementation

Before any manipulation, the Tyness and the board must be disconnected.

The board must be installed on the connectors on the locations EXT.1 and/or EXT.2 of the Tyness.

The wires must be inserted into the terminals.

We recommend the use of a cable of type SYT1 AWG20 shielded between the connection terminal block of the cables of the sensors and the connectors of the board.

The inputs must be configured via the switch in 0-10V (switch in low position) or in 4-20 mA (switch in high position).

A serigraphy in the bottom right corner of the board gives a reminder of the configuration of the switches. The far left switch corresponds to input 1, the second to input 2, etc.