Settings

The board is configured with the Tyness Configurator software.

Always use the latest version of the Tyness Configurator and check that your Tyness has the latest version of the firmware. If necessary, carry out an update.

Configuration steps

1 – Click on “Config” of the board 4-20mA / 0-10V


2 – In the insert “Enabled channels”, define which inputs will be active. To do so, select:
“Input 1” and/or “Input 2” and/or “Input 3” and/ or “Input 4”

3 – Define the period of sending of the readings: “Measure periodicity”

4 – Define the type of input (4-20mA or 0-10V) for each input.

ATTENTION: the configuration on the Tyness confiscator must correspond to the physical configuration of the switches on the board!

5 – Once all the values are entered, validate by clicking on “Write” If the operation has succeeded, a window displays “operation successful”.

Validate by clicking on OK
Your TYNESS-OPT-ANA board is ready to operate.

Verification of the readings

It is possible to display the values of the readings by placing the mouse cursor on the image of the analog board.