Product installation
Mounting options
Fixing magnet
The TYNESS-FIX-AIMANT kit contains 2 round magnets, two solid metal washers and 2 fixing bolts (Torx T8 imprint).
It makes it possible to fix the TYNESS on every on any magnetic surface or, for the non-magnetic surfaces, on the washers provided. In this specific case, the washers must be fixed to the surface (for example, using a double-sided adhesive).
Installation :
- Remove the solid washers from the magnet by sliding them sideways
- Position the magnets in the slots provided for this purpose on the back of the case. The face containing the entry cone must be visible.
- Insert the screw into the magnet and screw.
- To use the metal washers, place them on the magnets, add the adhesive on them and position the Tyness case. Once the adhesive holds, remove the case.
DIN rail mounting
The TYNESS-FIX-RAIL contains 2 parts: a base and a movable and adjustable strip.
It is used to fix the Tyness horizontally or vertically on a DIN rail. On horizontal position, it allows to position the Tyness at two heights per position.
The Tyness can be removed from the DIN rail by manipulating the movable strip with a classic screw-driver.
The TYNESS-FIX-RAIL comes with 2 mounting screws
Installation :
- Place the support in the chosen position (horizontal or vertical) and at the required height
- If needed, adjust the strip height
- Screw the 2 screws.
Strip setting :
Depending on the positioning of the FIX-RAIL, the strip must be adjusted to remain accessible.
If the upper part of the strip protrudes from the TYNESS (for example with a TYNESS in a low position), it can be cut off using cutting pliers.
