Product installation

Mounting and disassembly

This equipment must be installed on a DIN 35mm rail mounted horizontally on the electrical panel.
Make sure to snap the box properly into the DIN rail.
Make provision for the location of 5 modules to install the product on the electrical panel. To disassemble, use a flat head screwdriver to loosen the black clip located under the product.

Prerequisite

A 5V DC-2A power supply must be used to power the SQUID. The wiring of the Safety Extra Low Voltage circuits must be maintained and kept separated from circuits carrying hazardous voltages.

• Connection of the measurement  

Connect the measurement probes to the 12 connectors on the top and bottom of the equipment. Current must not exceed the maximum specification of the clamp.