Product installation
Mounting options Fixing magnet The TYNESS-FIX-AIMANT kit contains 2 round magnets, two solid metal washers and 2 fixing bolts (Torx T8 imprint). It makes it possible to fix the TYNESS on every on any magnetic surface or, for the non-magnetic surfaces, on the
Power supply
Power mode The Tyness can be powered using one several different modes: - External power using a power pack (see TYNESS-ALIM-BLOC-5V) or a DIN rail power supply (see ALIM-RAIL-5V) - Option : External case containing a 3.6V lithium battery operation, refer to the
Available options
TYNESS-OPT-PACK-PILE : External case containing a 3.6V lithium battery - 19Ah. The option includes sensor adaptation for battery operation. Batteries are available at the link below for supply: https://www.tme.eu/fr/en/details/eve-er14505_s/batteries/eve-battery-co/eve-er14505-std-3-6v-2-7ah/ TYNESS-OPT-ANT-EXT : Each TYNESS reference is available on request with an external antenna connector (ANTMAGNSUP). Antenna not supplied. TYNESS-OPT-WATERPROOF
Radio communication
The TYNESS-FIX-RAIL periodically sends its sensor measurements via a LoRaWAN™ radio link. In order to configure the Tyness sensor on a LoRaWAN™ network, you must have the unique EUID identification code, indicated on each product, as well as the two AppEUI
Hazards and Warnings
Manufacturer is not responsible for the user's failure to comply with the instructions contained in this manual. Any service performed on this product must be completed by a qualified individual. Replacement of this product must be performed by a qualified individual. Failure
Certifications and Conformities
CEM EN 61000-6-2 : Immunity for industrial environments EN 61000-6-3 : Emissions for residential environments EN 55022 : Immunity IT equipment Radio EN 30022 Sécurité EN 61010 : IT equipment
References
SQUID-HC-LORAWAN : The LoRaWAN™ version of the SQUID allows currents to be measured up to 600A. KIT-SQUID-HC-LORAWAN : Kits with a SQUID-HC-LORAWAN, and all necessary accessories: A power supply with attachment to a DIN rail 230 VAC-5VDC (ref: ALIM-RAIL-5V), and a magnetic antenna
Product description
The SQUID is a sensor equipped with 12 current measurement clamps which send measured current values by means of a wireless LoRaWAN link. The products sends the consumption index of the 12 clamps in Ah (in orange in the graph bellow)
Product installation
Mounting and disassembly This equipment must be installed on a DIN 35mm rail mounted horizontally on the electrical panel. Make sure to snap the box properly into the DIN rail. Make provision for the location of 5 modules to install the product on