The sensor enables to make different measurements. Here below are the wiring methods for each one. The technical characteristics are described at the bottom of the documentation.   Measurements of current: The measurement of current is carried out by means of the

Positioning of the product The product must be positioned in a way that does not make it difficult to operate disconnector devices. The product must be installed in an indoor environment. Product dimensions Mounting on DIN rail The product must be installed on a

The product must be powered by a 24VDC power supply and provide a minimum current of 1A. Connect the cable marked power supply of the product to this power supply. The red wire on the 24V and the black wire

A configuration software is available for the product. This software enables you to configure and update the product. The procedure below describes how to connect to the product Implementation Power the Tyness Download the Tyness Configurator software. This software is available

The TYNESS-FACTORY is a multifunctional LoRaWan radio sensor equipped with a remote omnidirectional magnetic antenna. It enables to perform : 3 current measurements by current clamps 2 temperature measurements by PT100 probes 2 digital input measurements 2 analog measurements 0-24V

The manufacturer cannot be held responsible if the instructions in this manual are not followed. Any intervention on the product must be carried out by a qualified person. The product must be replaced by a qualified person. The device must be used in

CEM EN 61000-6-2 :  Immunity for industrial environment EN 61000-6-3 :  Emission for residential environment EN 55022 : Immunity IT equipment Radio EN 300220 : Electromagnetic compatibility and radio spectrum for short range devices Security EN 61010 :  Electrical

Le capteur permet d'effectuer différentes mesures. Voici ci-dessous les méthodes de câblage de chacune. Les caractéristiques techniques sont décrites en bas de documentation.   Mesures de courant: La mesure de courant est effectuée au moyen des 3 pinces ampèremétriques ouvrante connectée au capteur

Le nettoyage du produit doit s'effectuer avec un chiffon sec, doux qui ne peluche pas. Enlevez les dépôts incrustés avec un chiffon légèrement humide. N’employez jamais de nettoyant, d’alcool ou de diluant.