The board can be set up on:● the TYNESS ENERGY (1 location)● the TYNESS MODULAR (2 locations).The board comprises two terminal blocks of type WAGO series 2059.One terminal block for the M-Bus connection cable (a standardtelephone cable – jYStY Nx2x0.8

TYNESS-OPT-MBUS Additional M-BUS Board enabling to read field M-Bus sensors (M-Bus slaves) counters of calories, water, and electrical energy. Comprises a power supply 230 V AC – 36 V DC for the TYNESS ENERGY and TYNESS MODULAR Ewattch which is necessary for

As the Tyness enables a wireless connection in LoRa mode to a data concentrator, the TYNESS-OPT-MBUS board was designed to read counters located near the Tyness. The M-Bus protocol is a standardized protocol according to the European standard EN 13757. A number of M-Bus

Manufacturer is not responsible for user’s failure to comply with the instructions contained in this manual.Any service performed on this product must be completed by a qualified individual.Replacement of this product must be performed by a qualified individual.Failure to use

The description of the radio exchange format is available upon request.

13, Rue Maurice Jeandon 88100 Saint- Dié des Vosges FRANCE sales@ewattch.fr www.ewattch.com

The board is configured with the Tyness Configurator software. Always use the latest version of the Tyness Configurator and check that your Tyness has the latest version of the firmware. If necessary, carry out an update. Step 1 1 - Click on « Config

This mode of functioning will be used when you wish, for example, to send back on the network LoRa the data coming from an existing ModBus network. The master of the ModBus network writes the preferred values in the table of

This mode will be used when you wish to read counters configured in slave mode. The board issues Modbus requests to read each counter (it is the master on the network, the counters are the slaves) and then radio transmits the

Pinout of the terminal block: Configuration with the: The resistances of polarization Pull Up and Pull Down must only be installed in a single place of the Bus, usually at the level of the master. In this case, move switches 2 and 3 to