Pinout of the terminal block: Configuration with the: The resistances of polarization Pull Up and Pull Down must only be installed in a single place of the Bus, usually at the level of the master. In this case, move switches 2 and 3

This mode will be used when you wish to read counters configured in slave mode. The board issues Modbus requests to read each counter (it is the master on the network, the counters are the slaves) and then radio transmits the

This mode of functioning will be used when you wish, for example, to send back on the network LoRa the data coming from an existing ModBus network. The master of the ModBus network writes the preferred values in the table of

The board is configured with the Tyness Configurator software. Always use the latest version of the Tyness Configurator and check that your Tyness has the latest version of the firmware. If necessary, carry out an update. Step 1 1 - Click on « Config

The TYNESS-OPT-MODBUS board is an additional ModBus interface board enabled to communicate in master or slave mode. In master mode, it enables to read the data of one or more sensors communicating in ModBus so as to copy the Modbus tables to the

Allocation of the terminal blocks: In its AC version, the board is compatible with the 50 Hertz and the 60 Hertz.

The board is configured with the Tyness Configurator software Always use the latest version of the Tyness Configurator and check that your Tyness has the latest version of the firmware. If necessary, carry out an update. 1 – Click on “Config” of the

It is possible to read with the Tyness Configurator software the number of pulses counted by the Tyness. To do so, position the mouse on the image of the board, and the two counting indexes will display.

The Tyness sensor transmits its data in raw format. The section below shows you how to decode the frames (Payload) sent by the Tyness. Case of two inputs configured in counting : Case of two inputs configured in reading of status of inputs