Additional boards
Every Tyness extension board has its own data sheet. To consult the documentation, click on the image which will send you back to the documentation of this one.
Références
The TYNESS-OPT-ANA board is an extension board with 4 analogue inputs configurable in 0-10V and 4-20 mA with common ground. It reads information from any sensor with 0-10V and / or 4-20 mA analog output
Example : a PLC, a variable speed drive, a flow meter, etc.
M-BUS extension board to pick up M-Bus field sensors (M-Bus slaves) such as calorie, water, electrical energy meters…
The TYNESS-OPT-PT100 board is extension board with 4 inputs for temperature measurement by PT100 3-wire probes.
This extension board has 3 current measurement inputs by soft loops (Rogowski)
The MODBUS extension board has a ModBus interface for communicating in master or slave mode.
This board has 3 current measurement inputs with clip-in clips (not included)
This extension board has 2 digital inputs allowing the data of all types of meters to be traced with a dry contact type pulse output.
• TYNESS-OPT-2IN-12_24V_DC • TYNESS-OPT-2IN-12_24V_AC
These extension boards make it possible to detect the 12-24V AC or DC voltage: pulse counting, state detection, time counting, etc.
This extension board has 2 optical sensor inputs capable of counting light pulses.
Use case: interfacing with an electricity meter using its blinking LED.
This additional card has 2 24V analog inputs, 2 12 to 24V digital inputs, and 2 temperature inputs via PT100.
Example of use: Interfacing with a production machine.