Card settings

The board is configured with the Tyness Configurator software.
Always use the latest version of the Tyness Configurator and validate that your Tyness has the latest version of the firmware. If necessary, carry out an update.

Click on “Config” of the board

• Define the period of sending the readings: insert “periodicity”
• Choose “Irms enable” if you want the Tyness to also transmit the RMS current, in milliamps read at the moment of the transmission.

Additional configurations specific to the Rogowski board :

• select the filter adapted to the frequency of your electrical network. (50Hz or 60Hz)
• in the case of a board with connectors: enter the calibration coefficients indicated on each of the loops in the section “Calibration coefficients”. If not, leave these values at 10,000.
• Once all the values are entered, validate by clicking on “Write”.

If the operation is successful, a window displays “operation successful”.
Validate by clicking on OK.

Your board is ready to operate