Necessary prerequisites for compatibility between an Mbus meter and a Tyness opt Mbus card Water meter : The following information (VIF) must be found in the data available via a measurement data query. VIF code (Value information field) Description: volume Coding: E001 0nnn Range: 10(nnn-6) m3

  13, Rue Maurice Jeandon88100 Saint-Dié des VosgesFRANCEsales@ewattch.fr  www.ewattch.com

A Tyness fitted with an M-BUS board transmits its data in raw format on the different LoRaWAN networks. The section below shows you how to decode the frames (Payload) sent by the Tyness. The following table describes the encoding of the data in

The board is configured with the Tyness Configurator software. Always use the latest version of the Tyness Configurator and check that your Tyness has the latest version of the firmware. If necessary, carry out an update. Step 1 ● Click on “Config” of the

Above all, the Tyness and the board must be disconnected. The board must be installed carefully and with precision of the connectors on the locations EXT.1 and/or EXT.2 of the Tyness. The M-Bus bus cable of the type standard telephone cable – jYStY

Dimensions: 1 additional standard location for Tyness Connectors: ● 1 connector type WAGO series 2059 for the bus M-Bus (0.14 to 0.34 mm2- 26 to 22 AWG) ● 1 connector type WAGO series 2059 for the power supply (0.14 to 0.34 mm2- 26 to 22 AWG) ●

The board can be set up on:● the TYNESS ENERGY (1 location)● the TYNESS MODULAR (2 locations).The board comprises two terminal blocks of type WAGO series 2059.One terminal block for the M-Bus connection cable (a standardtelephone cable – jYStY Nx2x0.8

TYNESS-OPT-MBUS Additional M-BUS Board enabling to read field M-Bus sensors (M-Bus slaves) counters of calories, water, and electrical energy. Comprises a power supply 230 V AC – 36 V DC for the TYNESS ENERGY and TYNESS MODULAR Ewattch which is necessary for

As the Tyness enables a wireless connection in LoRa mode to a data concentrator, the TYNESS-OPT-MBUS board was designed to read counters located near the Tyness. The M-Bus protocol is a standardized protocol according to the European standard EN 13757. A number of M-Bus

Manufacturer is not responsible for user’s failure to comply with the instructions contained in this manual.Any service performed on this product must be completed by a qualified individual.Replacement of this product must be performed by a qualified individual.Failure to use