Installation du produit
Positionnement du produit Le produit doit être positionner de manière à ne pas rendre difficile la manoeuvre de dispositifs de sectionnement. Le produit doit être installé dans un environnement intérieur. Dimensions du produit Fixation sur rail DIN Le produit doit être installé sur un rail
Alimentation du capteur
Le produit doit être alimenté par une alimentation d'une tension de 24VDC et fournissant un courant minimum de 1A. Connecter le câble repéré alimentation du produit à cette alimentation. Le fil rouge sur le 24V et le fil noir sur le
Caractéristiques techniques
ALIMENTATION Tension d'alimentation : 24VDC +-5% Puissance : 1,2W Longueur du câble d'alimentation : 1 mètres Fluctuation de la tension d'alimentation : ±5% de la tension nominale MESURES DE COURANT PAR PINCES OUVRANTES Sections/courants maximales admissibles : 10mm/75A, 16mm/100A, 24mm/300A, 36mm/600A Circuit
Homologations et conformités
FCC compliance statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
Dangers et avertissements
Le non-respect des indications de la présente notice ne saurait engager la responsabilité du constructeur. Toute intervention sur le produit doit être effectuée par une personne qualifiée. Le remplacement du produit doit être effectué par une personne qualifiée. L’appareil doit être utilisé selon
Cleaning the product
The cleaning of the product should be done with a dry, soft and lint-free cloth. Remove embedded deposits with a slightly damp cloth. Do not use any cleaner, alcohol or thinner.
Technical Specifications
POWER SUPPLY Voltage : 24VDC +-5% Power : 1,2W Power cable length : 1 meter (39,07 inches) Power supply voltage Fluctuation : ±5% of rated voltage POWER CURRENT MEASUREMENTS BY OPENING PINS Maximum allowable current/sections : 10mm/75A, 16mm/100A, 24mm/300A, 36mm/600A Measurable circuit
Measurements
The sensor enables to make different measurements. Here below are the wiring methods for each one. The technical characteristics are described at the bottom of the documentation. Measurements of current: The measurement of current is carried out by means of the
Product description
The TYNESS-FACTORY is a multifunctional LoRaWan radio sensor equipped with a remote omnidirectional magnetic antenna. It enables to perform : 3 current measurements by current clamps 2 temperature measurements by PT100 probes 2 digital input measurements 2 analog measurements 0-24V