AMBIANCE-LORAWAN AMBIANCE SENSOR LoRaWAN™ with reading of the temperature, humidity, level of presence, luminosity and optional CO2. It can be fitted with an alarm LED indicating a high CO2 level. This sensor has a version adding a survey feature enabling to obtain the

Installation of the sensor Mounting This device can be installed in several ways: screwed to the wall Option: perform double-sided mounting To simplify its installation, it is necessary to separate the rear part of the housing using a screwdriver. All you need to

  The AMBIANCE is a LoRaWAN™ complete sensor which can perform five types of reading: temperature, humidity, detection of presence, luminosity and optional CO2 reading. This product is battery-operated and therefore improves the freedom of positioning of the product. This sensor can

Radio communication: LoRaWan LoRaWan mode: OTAA ADR: activated Messages confirmed: deactivated Periodic reconnection to the LoRawan network: deactivated Time between two radio communication of mesures: 10 minutes CO2 threshlold for warning LED: 4 configured threshold, 1200ppm, 2000ppm, 3000ppm and

It is possible to configure Ambiance using configuration software via USB. This software is downloadable here. This section describes its use.   Connection Start with running the software. Once the software is running, connect a micro USB cable to the Ambiance. Select the port corresponding to

The Ambiance sensor, thanks to its infrared sensor, is able to count the time during which a room, a corridor, or more generally an area is used. It transmits at regulatar interval this duration as well as its other measurements using

The AMBIANCE SENSOR transmits its data in a raw format over the different LoRaWAN™ public and private networks. The section below shows you how to decode the frames (PayLoad) sent by the AMBIANCE.   Periodic frames The periodic frames contain the data measured

POWER SUPPLY Voltage: 3.6 VDC Battery life: up to 10 years depending on use Total battery capacity: 5.2 Ah VOLTAGE USING EXTERNAL POWER (optional): 5 to 12 V DC (option requiring minimum order quantity)   MEASUREMENTS Temperature measurement Temperature: 5 to 60°C      

Mounting and disassembly This equipment must be installed on a DIN 35mm rail mounted horizontally on the electrical panel. Make sure to snap the box properly into the DIN rail. Make provision for the location of 5 modules to install the product on

LoRaWAN™ Configuration The SQUID periodically transmits current measurements performed on his 12 measurement clamps in the form of consumption indexes (Ah) via a LoRaWAN™ radio link To be able to configure a SQUID on the LoRaWAN™ network, you must use the following