The board can be set up on: ● the sensors TYNESS ENERGY (1 location) ● the TYNESS MODULAR sensors (2 locations) The board functions in communication mode ModBus RTU RS485. The transmission speed is configurable from 1200 to 57600 bauds. It is comprised of one

The TYNESS-OPT-MODBUS board is an additional ModBus interface boardenabled to communicate in master or slave mode.In master mode, it enables to read the data of one or more sensorscommunicating in ModBus so as to copy the Modbus tables to the

Manufacturer is not responsible for user’s failure to comply with the instructions contained in this manual. Any service performed on this product must be completed by a qualified individual. Replacement of this product must be performed by a qualified individual. Failure to use

  13, Rue Maurice Jeandon 88100 Saint- Dié des Vosges FRANCE sales@ewattch.fr   www.ewattch.com

The Tyness sensor transmits its data in raw format. The section below shows you how to decode the frames (Payload) sent by the Tyness. Case of two inputs configured in counting: Case of two inputs configured in reading of status of inputs: Case of

It is possible to read with the Tyness Configurator software the number ofpulses counted by the Tyness.To do so, position the mouse on the image of the board, and the two countingindexes will display.

The board is configured with the Tyness Configurator softwareAlways use the latest version of the Tyness Configurator and check that your Tyness hasthe latest version of the firmware. If necessary, carry out an update.1 – Click on “Config” of the

Allocation of the terminal blocks:In its AC version, the board is compatible with the 50 Hertz and the 60 Hertz.

A Tyness can be fitted with an additional board for digital inputs. There are 5 versions of this board: ● a version for up to 2 dry contacts, compatible with all inputs without voltage. Reference : TYNESS-OPT-DIGITAL-2IN ● a version for up to 4