Un Tyness peut être équipé d’une carte additionnelle pour liaison téléinformation client. Elle dispose d'un port pour liaison téléinformation client des compteurs Enedis et de deux entrées digitales. Le port TIC (Téléinformation client) est compatible avec les compteurs suivants: Bleu, Linky,

Dimensions: 1 additional standard location for Tyness Connectors: 1 connector, 3 terminals, type AVX series 9276 (2/10° to 8/10° - 18 to 24 AWG) rigid and flexible multi-strands Number of M-BUS slaves: 15 slave maximum Radio data: 40 bytes per radio transmission

Pinout of the terminal block: Configuration with the: The resistances of polarization Pull Up and Pull Down must only be installed in a single place of the Bus, usually at the level of the master. In this case, move switches 2 and 3

This mode will be used when you wish to read counters configured in slave mode. The board issues Modbus requests to read each counter (it is the master on the network, the counters are the slaves) and then radio transmits the

This mode of functioning will be used when you wish, for example, to send back on the network LoRa the data coming from an existing ModBus network. The master of the ModBus network writes the preferred values in the table of

The board is configured with the Configurator software. Always use the latest version of the Configurator and check that your Tyness has the latest version of the firmware. If necessary, carry out an update. Step 1 1 - Click on « Config » of

The description of the radio exchange format is available upon request.

Manufacturer is not responsible for user’s failure to comply with the instructions contained in this manual. Any service performed on this product must be completed by a qualified individual. Replacement of this product must be performed by a qualified individual. Failure to use

The TYNESS-OPT-MODBUS board is an additional ModBus interface board enabled to communicate in master or slave mode. In master mode, it enables to read the data of one or more sensors communicating in ModBus so as to copy the Modbus tables to the

The board can be set up on: ● the TYNESS MODULAR sensors (2 locations) The board functions in communication mode ModBus RTU RS485. The transmission speed is configurable from 1200 to 57600 bauds. It is comprised of one terminal block 3 terminals of type