This mode of functioning will be used when you wish, for example, to send back on the network LoRa the data coming from an existing ModBus network. The master of the ModBus network writes the preferred values in the table of

This mode will be used when you wish to read counters configured in slave mode. The board issues Modbus requests to read each counter (it is the master on the network, the counters are the slaves) and then radio transmits the

Pinout of the terminal block: Configuration with the: The resistances of polarization Pull Up and Pull Down must only be installed in a single place of the Bus, usually at the level of the master. In this case, move switches 2 and 3 to

Dimensions: 1 additional standard location for Tyness Connectors: 1 connector, 3 terminals, type AVX series 9276 (2/10° to 8/10° - 18 to 24 AWG) rigid and flexible multi-strands Number of M-BUS slaves: 15 slave maximum Radio data: 40 bytes per radio transmission

The board can be set up on: ● the sensors TYNESS ENERGY (1 location) ● the TYNESS MODULAR sensors (2 locations) The board functions in communication mode ModBus RTU RS485. The transmission speed is configurable from 1200 to 57600 bauds. It is comprised of one

The TYNESS-OPT-MODBUS board is an additional ModBus interface boardenabled to communicate in master or slave mode.In master mode, it enables to read the data of one or more sensorscommunicating in ModBus so as to copy the Modbus tables to the

Manufacturer is not responsible for user’s failure to comply with the instructions contained in this manual. Any service performed on this product must be completed by a qualified individual. Replacement of this product must be performed by a qualified individual. Failure to use

  13, Rue Maurice Jeandon 88100 Saint- Dié des Vosges FRANCE sales@ewattch.fr   www.ewattch.com

The Tyness sensor transmits its data in raw format. The section below shows you how to decode the frames (Payload) sent by the Tyness. Case of two inputs configured in counting: Case of two inputs configured in reading of status of inputs: Case of

It is possible to read with the Tyness Configurator software the number ofpulses counted by the Tyness.To do so, position the mouse on the image of the board, and the two countingindexes will display.