Le non-respect des indications de la présente notice ne saurait engager la responsabilité du constructeur. Ce produit doit être installé par un professionnel, dans un environnement intérieur et de manière à ne pas rendre difficile la manœuvre du dispositif de sectionnement. Toute

The cleaning of the product should be done with a dry, soft and lint-free cloth. Remove embedded deposits with a slightly damp cloth. Do not use any cleaner, alcohol or thinner.

The sensor enables to make different measurements. Here below are the wiring methods for each one. The technical characteristics are described at the bottom of the documentation.   Measurements of current: The measurement of current is carried out by means of the

13, Rue Maurice Jeandon 88100 Saint-Dié des Vosges FRANCE sales@ewattch.fr www.ewattch.com

POWER SUPPLY Voltage : 24VDC +-5% Power : 1,2W Power cable length : 1 meter (39,07 inches) Power supply voltage Fluctuation : ±5% of rated voltage POWER CURRENT MEASUREMENTS BY OPENING PINS Maximum allowable current/sections : 10mm/75A, 16mm/100A, 24mm/300A, 36mm/600A Measurable circuit

The product must be powered by a 24VDC power supply and provide a minimum current of 1A. Connect the cable marked power supply of the product to this power supply. The red wire on the 24V and the black wire

Positioning of the product The product must be positioned in a way that does not make it difficult to operate disconnector devices. The product must be installed in an indoor environment. Product dimensions Mounting on DIN rail The product must be installed on a

The TYNESS-FACTORY is a multifunctional LoRaWan radio sensor equipped with a remote omnidirectional magnetic antenna. It enables to perform : 3 current measurements by current clamps 2 temperature measurements by PT100 probes 2 digital input measurements 2 analog measurements 0-24V

FCC compliance statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause