Dimensions:1 additional standard location for TynessConnectors:● 1 connector● 8 terminals type AVX series 9276 (2/10° to 8/10° - 24 to 18 AWG)● Rigid and flexible multi-strandsNumber of inputs:4 individually configurable inputs in 0-10V or 4-20mA with common mass in all of

REFERENCE: TYNESS-OPT-ANA The TYNESS-OPT-ANA board is an additional board comprising 4 analog inputs configurable in 0-10V and 4-20 mA with common mass. It enables to read the information coming from any sensor with an analog 0-10V and/or 4-20 mA output For example: an automaton,

Manufacturer is not responsible for user’s failure to comply with the instructions contained in this manual. Any service performed on this product must be completed by a qualified individual. Replacement of this product must be performed by a qualified individual. Failure to use

Necessary prerequisites for compatibility between an Mbus meter and a Tyness opt Mbus card Water meter : The following information (VIF) must be found in the data available via a measurement data query. VIF code (Value information field) Description: volume Coding: E001 0nnn Range: 10(nnn-6) m3

  13, Rue Maurice Jeandon88100 Saint-Dié des VosgesFRANCEsales@ewattch.fr  www.ewattch.com

A Tyness fitted with an M-BUS board transmits its data in raw format on the different LoRaWAN networks. The section below shows you how to decode the frames (Payload) sent by the Tyness. The following table describes the encoding of the data in

The board is configured with the Tyness Configurator software. Always use the latest version of the Tyness Configurator and check that your Tyness has the latest version of the firmware. If necessary, carry out an update. Step 1 ● Click on “Config” of the

Above all, the Tyness and the board must be disconnected. The board must be installed carefully and with precision of the connectors on the locations EXT.1 and/or EXT.2 of the Tyness. The M-Bus bus cable of the type standard telephone cable – jYStY

Dimensions: 1 additional standard location for Tyness Connectors: ● 1 connector type WAGO series 2059 for the bus M-Bus (0.14 to 0.34 mm2- 26 to 22 AWG) ● 1 connector type WAGO series 2059 for the power supply (0.14 to 0.34 mm2- 26 to 22 AWG) ●

The board can be set up on:● the TYNESS ENERGY (1 location)● the TYNESS MODULAR (2 locations).The board comprises two terminal blocks of type WAGO series 2059.One terminal block for the M-Bus connection cable (a standardtelephone cable – jYStY Nx2x0.8