13, Rue Maurice Jeandon 88100 Saint-Dié des Vosges FRANCE sales@ewattch.com +33(0)3.29.57.75.97 www.ewattch.com

Manufacturer is not responsible for user’s failure to comply with the instructions contained in this manual.Any service performed on this product must be completed by a qualified individual. Replacement of this product must be performed by a qualified individual.Failure to

A Tyness can be fitted with an additional board for digital inputs. There are 5 versions of this board: ● a version for up to 2 dry contacts, compatible with all inputs without voltage. Reference : TYNESS-OPT-DIGITAL-2IN ● a version for up to 4

Allocation of the terminal blocks: In its AC version, the board is compatible with the 50 Hertz and the 60 Hertz.

The board is configured with the Configurator software Always use the latest version of the Configurator and check that your Tyness has the latest version of the firmware. If necessary, carry out an update. 1 – Click on “Config” of the pulse board 2

It is possible to read with the Configurator software the number of pulses counted by the Tyness. To do so, values are visible on the left menu when you select the board.

The Tyness sensor transmits its data in raw format. The section below shows you how to decode the frames (Payload) sent by the Tyness. Case of two inputs configured in counting : Case of two inputs configured in reading of status of inputs

13, Rue Maurice Jeandon 88100 Saint-Dié des Vosges FRANCE sales@ewattch.com +33(0)3.29.57.75.97 www.ewattch.com

La carte se paramètre avec le logiciel Configurator. Utilisez toujours la dernière version du Configurator et validez que votre Tyness dispose de la dernière version du firmware. Si besoin, procédez à une mise à jour. 1 - Cliquer sur « Config » de la carte