The board is configured with the Tyness Configurator software. Always use the latest version of the Tyness Configurator and validate that your Tyness has the latest version of the firmware. If necessary, carry out an update. Click on “Config” of the board

The Tyness and the board must be disconnected.The board must be installed carefully and with precision of connectors onthe locations EXT.1 and/or EXT.2 of the Tyness.In the case of the board fitted with connectors, the wires of the inputs must be

Allocation of the terminal blocks:

The alternative current board for Tyness Ewattch measures at high frequency, the currents on each of its 3 inputs. It enables to measure the current consumed by a device with great precision. The data made available for each of the reading inputs are

Manufacturer is not responsible for user’s failure to comply with the instructions contained in this manual.Any service performed on this product must be completed by a qualified individual.Replacement of this product must be performed by a qualified individual.Failure to use

  13, Rue Maurice Jeandon 88100 Saint- Dié des Vosges FRANCE sales@ewattch.fr   www.ewattch.com

A Tyness fitted with an ANA board transmits its data in a raw format on the different LoRaWAN networks. The section below shows you how to decode the frames (Payload) sent by the Tyness.

Certain sensors are powered by the data loop.In this case, a power supply must be integrated into the loop according to the following diagram where the receptor corresponds to the TYNESS-OPT-ANA board and the Transmitter corresponds to the sensor read.The 0V

The board is configured with the Tyness Configurator software.Always use the latest version of the Tyness Configurator and check that your Tyness has the latest version of the firmware. If necessary, carry out an update.Configuration steps1 – Click on “Config” of

Before any manipulation, the Tyness and the board must be disconnected. The board must be installed on the connectors on the locations EXT.1 and/or EXT.2 of the Tyness. The wires must be inserted into the terminals. We recommend the use of a cable