The board is configured with the Configurator software. Always use the latest version of the Configurator and check that your Tyness has the latest version of the firmware. If necessary, carry out an update. Step 1 ● Click on “Config” of the M-Bus

A Tyness fitted with an M-BUS board transmits its data in raw format on the different LoRaWAN networks. The section below shows you how to decode the frames (Payload) sent by the Tyness. The following table describes the encoding of the data in

Manufacturer is not responsible for user’s failure to comply with the instructions contained in this manual.Any service performed on this product must be completed by a qualified individual.Replacement of this product must be performed by a qualified individual.Failure to use

As the Tyness enables a wireless connection in LoRa mode to a data concentrator, the TYNESS-OPT-MBUS board was designed to read counters located near the Tyness. The M-Bus protocol is a standardized protocol according to the European standard EN 13757. A

TYNESS-OPT-MBUS Additional M-BUS Board enabling to read field M-Bus sensors (M-Bus slaves) counters of calories, water, and electrical energy. Comprises a power supply 230 V AC – 36 V DC for the TYNESS ENERGY and TYNESS MODULAR Ewattch which is necessary for

The board can be set up on: the TYNESS ENERGY (1 location) the TYNESS MODULAR (2 locations). The board comprises two terminal blocks of type WAGO series 20599. One terminal block for the M-Bus connection cable (a standard telephone cable – jYStY

13, Rue Maurice Jeandon 88100 Saint-Dié des Vosges FRANCE sales@ewattch.com +33(0)3.29.57.75.97 www.ewattch.com

Le Tyness permettant une liaison sans fil en mode LoRa vers un concentrateur de données, la carte TYNESS-OPT-MBUS a été conçue pour relever des compteurs situés à proximité du Tyness. Le protocole M-Bus est un protocole standardisé selon le standard européen

TYNESS-OPT-MBUS Carte additionnelle M-BUS permettant de relever des capteurs M-Bus terrains (esclaves M-Bus) des compteurs de calories, d'eau et d'énergie électrique. Comprends une alimentation 230 V AC - 36 V DC pour les TYNESS ENERGY et TYNESS MODULAR Ewattch qui est nécessaires

La carte peut être mise en place sur: les TYNESS ENERGY (1 emplacement) les TYNESS MODULAR (2 emplacements). La carte comporte deux borniers de type WAGO série 2059. Un bornier pour le câble de liaison M-Bus (un câble téléphone standard – jYStY